|
Standard TV Brackets & Mounts
more...
 Home
A/V Accessories & Cables
 Antennas
Audio Cables & Connectors
Blank Media
Headphones, Headsets
Maintenance & Care
Mounts & Brackets
 Flat-Panel TV Brackets,...
Other
Projector Mounts
Speaker Brackets & Mounts
Speaker Stands
Standard TV Brackets &...
TV Swivels
Other A/V Accessories
Remote Controls
Surge Protection, Filtration
Video Cables & Connectors
DVD & Home Theater
Gadgets & Other Electronics
Heating, Cooling & Air
Home Audio
Lamps, Lighting, Ceiling...
Major Appliances
Outdoor Power Equipment
Satellite, Cable TV
Televisions
Vacuum Cleaners &...
The Flat Display Mounting Interface (FDMI), also known as VESA Mounting Interface Standard (MIS) or colloquially as VESA mount, is a family of standards defined by the Video Electronics Standards Association for mounting flat panel monitors, TVs, and other displays to stands or wall mounts. It is implemented on most modern flat-panel monitors and TVs.
The first standard in this family was introduced in 1997 and was originally called Flat Panel Monitor Physical Mounting Interface (FPMPMI).
Variants
The original VESA mount (MIS-D) consisted of four screws arranged in a square, with the horizontal and vertical distance between the screw centers being 100 mm. This is still the most commonly used configuration for desktop computer displays. A 75 mm × 75 mm layout was defined for smaller displays.
The MIS-D screw holes have an M4 thread and are typically 10 mm deep. Appropriate fasteners (typically ~10 mm long) are often supplied with the mount rather than the display, but they are also easily available from many hardware stores.
The FDMI was extended in 2006 with a collection of additional screw patterns that are more appropriate for larger TV screens.
-
Examples of the full identification of a particular FDMI variant look like
- VESA MIS-D, 100, C
- VESA MIS-F, 200, 200, 6
where
the letter after MIS- identifies the part of the standard used, e.g.
part B, C, D, E for flat displays with 10–78 cm diagonal;
part F for flat displays with 79–230 cm diagonal;
;
for part D, a number identifies the 75 mm and 100 mm variants (100 or 75),;
for part F, a number pair identifies the maximum width and height of the mounting-hole pattern,;
for parts B–E, a final letter identifies the interface location on the flat display as center (C), top (T), bottom (B), left (L), right (R), top and bottom (T/B), or left and right (L/R),;
for part F, a final digit distinguishes between 10 mm deep M6 mounting holes (6) and 15 mm deep M8 holes (8).;
Compliance
In addition to mounting-hole patterns, the standard also specifies requirements for the location of cable exits. Manufacturers of FDMI compliant devices can license the use of a hexagonal "VESA mounting compliant" logo.
Further reading
Flat Display Mounting Interface Standard (FDMI), 1.0 Revision 1, VESA-2006-2, Video Electronics Standards Association, January 2006.;
Read more at Wikipedia.org
|
|
